QUANTA STRATOS S210 Series S210-X12RS

To Next Page

To Previous Page

INSTALLING HARDWARE INSTALLING THE HDD BACKPLANE (2.5” HDD W EXPANDER SKU)

2-54

2. Secure the HDD Backplane to the chassis with six (6)

screws.

Figure 2-80. Installing the 2.5” HDD Backplane Screws

3. Connect the power cable to the 10 Pin Power connector

on the HDD BP.

Power Connector

Main Page

Table of Contents2
Important Safety Instructions19
Revision History20
Introduction23
- System Features23
- Package Contents26
HDD System27
A Tour of the System27
HDD System Front Features29
- System HDD Introduction33
- Hard Disk Drive Configuration33
- System Rear Features34
  - System Rear View34
  - System I/O LED Description35
Safety Measures39
Top Cover40
- Opening the Top Cover40
- Closing the Top Cover41
Removing a 2.5" Hard Drive42
Hard Disk Drives42
Installing a 2.5" Hard Drive43
Removing a 3.5" Hard Drive44
Installing a 3.5" Hard Drive45
Power Supply Unit47
- Removing a Power Supply Unit47
- Installing a Power Supply Unit48
Mainboard Module49
- Removing a Mainboard Module49
- Installing a Mainboard Module50
Processor Heat Sinks52
- Removing a Heat Sink52
- Installing a Heat Sink53
Processors54
- Removing a Processor54
- Installing a Processor56
Memory Modules58
- General Guidelines58
- Removing a Memory Module58
- Installing a Memory Module59
- Memory Population Rules60
Pcie Riser Assembly63
- Removing the Pcie Riser Assembly63
- Installing the Pcie Riser Assembly64
Pcie Expansion Card65
- Removing the Pcie Expansion Card65
- Installing the Pcie Expansion Card66
Mezzanine Card67
- Installing a LAN Mezzanine Card67
- Removing a LAN Mezzanine Card69
- Installing a SAS 6G Mezzanine Card71
- Removing a SAS 6Gb Mezzanine Card75
Intelligent Battery Backup Unit79
- Installing an Ibbu79
- Removing an Ibbu80
Air Duct82
- Removing the Air Duct82
- Installing the Air Duct82
Fan Module Assembly83
- Removing Fan Module Assembly83
- Installing Fan Module Assembly84
Expander Backplane85
- Removing the Expander Backplane85
- Installing the Expander Backplane87
HDD Backplane90
Removing the HDD Backplane (2.5" HDD W Expander SKU)90
Installing the HDD Backplane (2.5" HDD W Expander SKU)91
Removing the HDD Backplane (2.5" HDD W/O Expander SKU)93
Installing the HDD Backplane (2.5" HDD W/O Expander SKU)96
Removing the HDD Backplane (3.5" HDD SKU)100
Installing the HDD Backplane (3.5" HDD SKU)102
- Bios104
BIOS Setup Utility105
- Operation105
- Setup Page105
- Entering BIOS Setup106
- Keyboard Commands106
- Menu Selection Bar108
- Server Platform Setup Utility Screens108
- Main Screen109
- Advanced Screen110
- Chipset Screen136
- Server Management Screen143
- Boot Option Screen149
- Security Screen153
- Exit Screen157
- Loading BIOS Defaults159
BIOS Update Utility160
- Recovery Mode161
- Recovery Flow161
Server Management163
- Console Redirection163
- PXE BIOS Support164
- Checkpoints164
Server Management Software174
- Server System Overview174
- BMC Key Features and Functions174
- Power System174
- Front Panel User Interface174
- LAN Interface176
  - Session and User176
- Serial over LAN176
- Time Sync176
- Sel176
- Platform Event177
  - Platform Event Filter177
- BMC Firmware Update177
  - DOS Recovery Utility177
  - Webui Update177
BMC Recovery178
- Recovery Process in DOS System178
- Recovery Process in Linux System178
Quanta Smash179
- System Level Commands180
- BMC Information184
Web Graphical User Interface (GUI) for ESMS185
- Using the Web GUI185
- Login185
- Dashboard186
- Server Information188
- FRU Information189
- Configuration Group195
- Remote Control228
  - Console Redirection228
  - Server Power Control235
- Maintenance Group236
- Log out238
- User Privilege239
  - Jumpers and Connectors240
Mainboard Jumpers and Connectors241
- Mainboard Connectors242
- Mainboard Jumpers243
Rail Kit Assembly245
- Installing the Rack Brackets246
Troubleshooting249
- Server Boot Issue Topics250
Installation Assembly Safety Instructions255
- Guidelines255
  - Safety Information259
Server Safety Information260
- Safety Warnings and Cautions260
- Intended Application Uses261
- Site Selection261
- Equipment Handling Practices262
- Power and Electrical Warnings262
  - Power Cord Warnings263
- System Access Warnings263
- Rack Mount Warnings264
- Electrostatic Discharge (ESD)265
- Other Hazards266
Product Regulatory Compliance Markings268
- Electromagnetic Compatibility Notices270
- FCC Verification Statement (USA)270
- Europe (CE Declaration of Conformity)270
- VCCI (Japan)271
- BSMI (Taiwan)271
- KCC (Korea)271
- Regulated Specified Components271
- Restriction of Hazardous Substances (Rohs) Compliance272
- End of Life / Product Recycling272

QUANTA STRATOS S210 Series S210-X12RS - Page 92

Table of Contents

Other manuals for QUANTA STRATOS S210 Series S210-X12RS

Related product manuals