INSTALLING HARDWARE REMOVING THE HDD BACKPLANE (2.5” HDD W/O EXPANDER SKU)
2-56
2. Remove four (4) screws from the 1:1 backplane.
Figure 2-82. Removing the 1:1 Backplane Screws
3. Slide the 1:1 BP toward the rear of the chassis until the
B2B Connector is free from the HDD BP.
Figure 2-83. 2.5” HDD Backplane Connectors
4. Continue to slide the 1:1 BP toward the rear of the chas-
sis until the BP is free of the chassis pins.
5. Remove the 1:1 BP from the chassis.
To Next Page
Loading...
