INSTALLING HARDWARE INSTALLING THE HDD BACKPLANE (2.5” HDD W/O EXPANDER SKU)
2-60
5. Slide the 1:1 BP toward the front of the chassis until the
B2B Connector is connected to the HDD BP.
Figure 2-90. Connecting the 1:1 Backplane
6. Secure the 1:1 BP to the chassis with four (4) screws.
Figure 2-91. Installing the Expander Backplane Screws
7. Connect the power cable to the 10 Pin Power connector
on the HDD BP.
8. Connect the following cables to the 1:1 backplane:
a. 10 pin Power connector for BP with +12V, +5V, +3.3V
b. SGPIO connector 3 for HDD 8 ~ 9.
To Next Page
Loading...
