Configuring Remote Access Users
Quantum Spark 1500, 1600 and 1800 Appliance Series R80.20.40 Locally Managed Administration Guide | 223
To configure Two-Factor Authentication:
1. On the VPN Remote Access Control Blade Control page, select Require users to confirm their
identity using Two-Factor Authentication.
2. Click Apply.
3. Click configure.
The Two-Factor Authentication Settings window opens.
4. In the Configuration tab, select SMS.
5. To use Check Point SMS, select Use Check Point SMS provider service.
6. If you select Use External SMS provider, enter the:
n
DynamicID URL.
n
Provider user name.
n
Provider password.
n
API ID.
n
Message to display (optional).
7. In the Advanced tab, under Dynamic ID Settings, enter the:
n
Length of the one-time password.
n
Amount of time in minutes until the password expires.
n
Maximum number of retries.
8. Under Country Code, enter the Default country code.
9. Click Apply.
To sign in with Two-Factor Authentication:
1. Connect to your VPN.
2. You are prompted for a DynamicID One Time Password (OTP) which is sent to your mobile phone via
SMS.
Notes:
n
VPN Two-Factor Authentication is per gateway, not administrator.
n
When you turn on Two-Factor Authentication, you enable it for all VPN clients. This means all VPN
clients must have a configured mobile phone number to connect.
To Next Page
Loading...
Need help?
General
