Need help?Do you have a question about the Radius GM300 and is the answer not in the manual?
Welcome to radio programming, GM300 features, and RSS usage.
Knowledge and tools required for RSS and radio programming.
Details about RSS subscription, model numbers, and support groups.
Shows required and optional equipment for radio programming setup.
Minimum and recommended platform requirements for RSS.
Explains computer parts, storage, DOS, and RSS with Windows.
Suggestions for organizing directories and files for radio archive data.
Procedures for installing and starting the RSS program.
Guide to understanding and moving through RSS menus and screens.
Explains different field types and how to change their values in RSS.
Setting default paths, ports, and screen colors for RSS.
Step-by-step guide for programming an 8-channel GM300 radio.
Instructions for cloning radios with identical personalities from an archive file.
Lists all features available for 8 and 16 channel GM300 models.
Limits transmissions when the channel is busy to reduce interference.
Forces radio into monitor mode before allowing transmission.
Sets the designated frequency in MHz for receiving messages.
Sets the designated frequency in MHz for sending outgoing signals.
Determines how priority channels are checked for activity during lookback.
Sets how often priority channels are sampled for activity.
Determines how long each channel is checked for carrier and PL.
Modifies pin functions via the ACCESSORY CONNECTOR CONFIGURATION screen.
Lists available packages for customizing the accessory connector.
Determines if high or low voltage signal activates pins.
Waits for mechanical switch bounce before acting on inputs.
Assigns functions to programmable pins on the connector.
To Next Page
General