Radius GM300 - Desired Features; Major Decisions Involved; Step-By-Step Programming Instructions

October, 1996 6880902Z36-B
3-3
GM300 Radio Service Software Manual Tutorials
Programming Basic Radios
3
3.2.2 Desired Features
The convention setup and maintenance radios will need the following features:
❏ A Transmit Frequency
❏ A Receive Frequency
❏ Private Line/Digital Private Line (TPL/DPL) Codes
❏ Carrier Squelch
❏ Time-Out Timer (TOT)
3.2.3 Major Decisions Involved
To program the desired features above, the approach with the RSS will be:
❏ Decide which radio model to use.
❏ Decide which frequencies to use.
❏ Pick the number of modes (channels) desired.
❏ Decide which feature systems to use (basic, scan, signalling).
❏ Decide which features to program radio-wide (all channels).
❏ Decide which features to program per-mode (individual channels only).
❏ Do the step-by-step specific programming instructions.
3.2.4 Step-by-Step Programming Instructions
Table 3-2 on page 3-4 is a chart of the desired features for each mode of the radio being programmed in
this tutorial. Check them off as you do them in the sections to follow. See Appendix I for a blank form you
can use for future radios.