Introduction GM300 Radio Service Software Manual
1-2
6880902Z36-B October, 1996
Prerequisites
1
The following are some of the features and functions available when using the RSS program:
(
* 16 Channel Model only
)
Figure 1-1. RSS Programmable Features and Functions
This radio customizing and servicing is accomplished by using a standard IBM-XT/AT (or compatible),
IBM convertible, or System/2 Model 30/50/70 computer.
Note: Prior to purchasing a computer, we recommend you test any computer's RSS “compatibility” by
connecting all the hardware, installing the software, starting the RSS and reading and writing data to
and from a radio. If problems occur, call the phone number on the front cover for help.
1.2 Prerequisites
To use RSS and to program the radios, we recommend a basic working knowledge of the following:
❏
Microcomputers.
❏
Microsoft Disk Operating System (MS-DOS), version 3.2 or later.
❏
The radio's available features (see Feature Chart in Basic Features section),
❏
The GM300 Study Guide, and the GM300 Operator's Manual.
❏
Your customers' needs.
For computer beginners, we shall teach some computer and DOS basics. However, this manual is written
for both beginners and advanced users, so the primary prerequisite for using RSS is the desire to program
and deliver an excellent radio to your customer.
1.3 Using This Manual
This manual is designed to teach basic feature programming and to speed up access to technical reference
information. It is intended for both beginners and advanced users of computers and RSS. To speed up
access to the information, we've included key words in the page headers, numerous tables and lists, and
a revised Table of Contents and reference sections. To help you better understand the information pre-
sented, we've expanded the Getting Started section, Glossary and Abbreviation list, and added a Tutori-
als section to get new users started faster. The table below lists suggested ways to use this manual.
GM300 RSS Programmable Features
GM300 RSS Service Functions
Transmit (Tx) frequencies
Receive (Rx) frequencies
PL/DPL codes
Signalling system parameters*
Scan lists and scan options
Accessory connector definition*
Reference oscillator alignment
Transmit deviation alignment
Transmit power alignment
Replaced power amplifier calibration
Replaced logic board calibration
Replaced RF board calibration
To Next Page
Loading...
Need help?
General
