P/N 016-0171-493 Rev. I 95
Tools Menu
7
CAN Sprayer/Spreader Control
Select ‘CAN Sprayer/Spreader Control’ if the field computer will be used to control up to four products (with
required multi-product activation key) via a CANbus system.
Note: If more than one product node has been installed with the field computer, be sure to
check that all product control nodes are addressed correctly before proceeding.
Touch the CAN Information icon (shown right) and review the CAN Diagnostics
section on page 30 to re-address the product nodes.
The Boom Master Options list is replaced by AccuBoom Options if ‘CAN Product Control’ is
selected. See the CAN Options section on page 97 for details.
CAN AccuRow Only
Select ‘CAN AccuRow Only’ if the field computer will be interfacing with an optional AccuRow system to
provide automatic section control for a multi-section planter implement. Refer to the AccuRow Calibration &
Operation Manual for additional set up and operation information.
CAN Planter Control
Select ‘CAN Planter Control’ if the field computer will be interfacing with an optional Raven OmniRow system.
The OmniRow system allows the field computer to control seed population rate and offers AccuRow, automatic
row or planter section shut off. Refer to the OmniRow
®
Calibration & Operation Manual for additional set up
and operation information.
Bogballe Calibrator Zurf
The field computer may be used in conjunction with the Bogballe Calibrator Zurf console for guidance and
monitoring of product applications using Bogballe weight systems. Refer to Appendix J, Serial Console
Interfaces, for additional information.
Kuhn/Rauch LH5000
The field computer may be used in conjunction with the Kuhn/Rauch LH5000 console for guidance and
monitoring of product applications using an existing Kuhn/Rauch system. Refer to Appendix J, Serial Console
Interfaces, for additional information.
To Next Page
Loading...
