Chapter 7
150 Envizio Pro™ and Envizio Pro II® Installation and Operation Manual
Configuring Section Labels
To customize the section labels displayed on the field computer, touch the ‘Configure Section Labels’ button.
The Section Labeling screen will display.
The currently configured section labels are displayed in boxes along the top of the screen. To begin configuring
section labels:
1. Touch the box of the first section to relabel. A red box will appear around the selected section.
2. Use the displayed keypad to enter the new section label. The asterisk (*) label can be used for “skipped”
sections or sections with a zero width value.
3. Repeat step 1 and step 2 until all sections have been configured with the desired label.
4. Touch the Accept to return to the Configure Sections screen.
Section Mapping
The Envizio Pro field computer allows the operator to customize the section to switch mapping to the operator
to quickly control multiple sections using a single switch. This feature also allows the operator to use a
standard 10 section switch box to control an implement with more than 10 sections.
Note: Version 1.30 is required on the Raven CAN switch box to manually map sections.
Verify section mapping is configured correctly before starting a job.
Automatically Configure Sections
If sections of the boom or implement are aligned end-to-end along the swath midpoint, select ‘Auto Configure.’
The field computer will automatically configure section locations.
After the field computer has configured sections, section locations can be modified by touching the Manually
Configure button.
To Next Page
Loading...
