COPYRIGHT © 2016 RED.COM, INC
RED RAVEN OPERATION GUIDE
955-0127_V6.3, REV-E | 152
CAMERA DOES NOT RECOGNIZE LENS
SYMPTOM
The camera does not recognize the attached lens.
POTENTIAL RESOLUTIONS
Ensure that the lens is compatible. For more information, go to “Lenses” on page 188.
Perform a Hardware Rediscover. For more information, go to “Rediscover (Hardware Rediscover)” on page
105.
CAMERA DISPLAYS N/A FOR APERTURE
SYMPTOM
The camera displays N/A for aperture when a lens is attached.
POTENTIAL RESOLUTIONS
Ensure that your lens is completely locked in place.
Perform a Hardware Rediscover. For more information, go to “Rediscover (Hardware Rediscover)” on page
105.
Re-install your camera firmware.
If your camera is on beta firmware, downgrade to the release build.
NOTE: Some lenses do not display the aperture information because they are incompatible.
CANNOT SEE MENUS ON LCD TOUCHSCREEN
SYMPTOM
The LCD touchscreen does not display menus.
POTENTIAL RESOLUTION
Double-tap the LCD touchscreen to exit Clean mode.
SCREEN FREEZES OR DOES NOT DISPLAY
SYMPTOM
The screen freezes or does not display.
POTENTIAL RESOLUTION
Perform a Hard Restore. For more information, go to “Perform a Hard Restore” on page 154.
LCD FLICKER
SYMPTOM
The LCD or monitor is flickering.
POTENTIAL RESOLUTIONS
Go to Menu > Settings > Display > Monitor Control and adjust the Frequency to 60 Hz.
Use a different cable.
Ensure cables are properly attached.
To Next Page
Loading...
Need help?
General
