RED RAVEN OPERATION GUIDE
COPYRIGHT © 2016 RED.COM, INC 955-0127_V6.3, REV-E | 157
INSTALL THE MEDIA BAY
WARNING: Before installing or removing the media bay, you MUST turn off the camera.
REQUIRED TOOL: T10 TORX driver
1. Turn off the camera.
2. Place the media bay on the camera, so that the mounting holes of the media bay align with the screw holes
of the camera.
3. Use a T10 TORX driver to tighten the four (4) captive screws by about two (2) turns in a cross pattern (“X”
pattern). DO NOT FULLY TIGHTEN.
4. Tighten the four (4) captive screws evenly. DO NOT exceed 70 in-oz, or damage may occur.
WARNING: DO NOT OVERTIGHTEN.
CAMERA KEEPS PROMPTING BLACK SHADE MESSAGE
SYMPTOM
Your camera keeps prompting you to black shade the camera.
POTENTIAL RESOLUTIONS
Ensure that you complete the sensor calibration process. For more information, go to “Sensor Calibration”
on page 100.
Go to Menu > Settings > Maintenance > Calibrate and select user1 Calibration Map. Click Set.
Go to Menu > Settings > Maintenance > Calibrate and delete all user-created calibration maps. Then reset
your camera’s default settings. For more information, go to “Reset Defaults” on page 105.
AUDIO BUFFER OVERFLOW WARNING
SYMPTOM
When you press the Record key, the error message “Audio Buffer Overflow Warning” displays.
POTENTIAL RESOLUTIONS
Perform a Secure Format of the SSD. For more information, see the DSMC Media Operation Guide, available
at www.red.com/downloads.
To Next Page
Loading...
Need help?
General
