To Next Page

To Previous Page

RED RAVEN OPERATION GUIDE

ADAPTIVE PREVIEW QUIET RECORD

NOTE: Target Temperature only affects standby mode.

 Record mode: The camera uses Quiet fan mode. For more information, go to “Quiet” on page 97.

 Standby mode: The camera uses Adaptive fan mode. For more information, go to “Adaptive (Target

Temperature)” on page 96.

QUIET

The fans self-adjust to maintain the lowest possible noise level in record and standby mode while still cooling

the camera.

MANUAL

Select a speed for the fans in both record and standby modes. The fans self-adjusts to maintain the selected

speeds. The default Maximum Record Speed is 75% and the default Maximum Preview Speed is 75%. The

range for both Maximum Record Speed and Maximum Preview Speed is 25–100%.

POST RECORD DELAY

Select the amount of time that it takes for the fan to switch from record to preview mode.

LENS

LENS TAB

The options below display when a supported lens is installed.

 Aperture: Enter the aperture value. The range and default depend on the lens.

 Focus: Enter the focal distance. The default value is the value from the lens. The range depends on the lens.

 Focus: Use the slider to change the focal distance. Manually changing the focal distance on the lens itself

does not cause the slider to move. This setting is only available if the lens is in AF mode.

 Init Lens: Initializes the lens.

LENS INFO TAB

The Info tab displays the attached lens mount and lens information.

Questions and Answers:

Need help?

Do you have a question about the RED Raven and is the answer not in the manual?

RED Raven Specifications

General