20 June 2005 SERVICE PROGRAM MODE TABLES
5-51
Service
Tables
5828 Network Setting
582850 1284 Compatibility
(Centro)
Enables and disables bi-directional communication on the
parallel connection between the machine and a computer.
[0~1/1]
0:Off
1: On
582852 ECP (Centro) Disables and enables the ECP feature (1284 Mode) for
data transfer.
[0~1/1]
0: Disabled
1: Enabled
582865 Job Spool Setting Switches job spooling spooling on and off.
0: No spooling 1: Spooling enabled
582866 Job Spool Clear This SP determines whether the job interrupted at power
off is resumed at the next power on. This SP operates
only when SP5828065 is set to 1.
1: Resumes printing spooled jog.
0: Clears spooled job.
This SP 8etermines whether job spooling is enabled or
dispabled for each protocol. This is a 8-bit setting.
0 LPR 4 BMLinks (Japan Only)
1 FTP (Not Used) 5 DIPRINT
2 IPP 6 Reserved (Not Used)
582869 Job Spool Protocol
3 SMB 7 Reserved (Not Used)
582877 IPv4 DNS Server 2
582878 IPv4 DNS Server 3
582879 Domain Name
(Ethernet)
Sets the IPv4 address for a DNS server. This address can
be used among devices that have IPv4 devices (Ethernet,
IPv4 Over 1394, IEEE 802.11b, etc.)
582884 Setting List PrintPrint
Settings List
Prints a list of the NCS parameter settings.
582890 TELNET Operation
SettingsTELNET (0:OFF
1:ON)
Disables or enables Telnet operation. If this SP is
disabled, the Telnet port is closed.
[0~1/1]
0: Disable
1: Enable
582891 Web Operation Web
(0:OFF 1:ON)
Disables or enables the Web operation.
[0~1/1]
0: Disable
1: Enable
582896 Rendezvous Operation This SP disables/enables Rendezvous operation.
This is a set of protocols that allows a device on an IP
network to automatically recognize and connect with other
devices (such as a printer) on a network. Once a new
device is connected to the network, it can be used
immediately by every computer on the network. No
special setup procedures or configuration settings are
required
1: Enable 0: Disable
To Next Page
Loading...
