Fusing
D086/D087 4-116 SM
2. Make sure that pressure roller bearing [C] at the front side is set as shown above.
Pressure Roller Stripper Plate Installation
When reinstalling the pressure roller stripper plate:
1. Set the springs [A] (front and rear) correctly as shown above.
2. Install the pressure roller stripper plate [B] in the fusing unit frame as shown above.
3. Turn the pressure roller stripper plate [B].
4. Hold the pressure roller stripper plate, and then install the pressure roller.
The pressure roller stripper plate is not supported before installing the pressure roller
in the fusing unit frame. If you stop holding, the pressure roller stripper plate can fall
To Next Page
Loading...
