Problem Causes Solutions
Sheets are curled when they
are output.
Certain types of A3 and 11
17 sheets can become
curled when they are output.
Paper misfeeds can occur if the output
tray is set to internal tray 2 and multiple
A3 or 11 17 sheets begin to curl as
they are output.
If sheets are curled when they are
output, raise the guide on internal tray
2. For details about raising the guide,
see "When Printouts on the Internal
Tray 2 Are Curled", Getting Started .
Cannot print in duplex
mode.
You have selected a paper
tray that is not set for duplex
printing.
Change the setting for "Apply Duplex"
in System Settings to enable duplex
printing for the paper tray. For details
about setting the "Apply Duplex", see
"Tray Paper Settings", Connecting the
Machine/ System Settings .
Cannot print in duplex
mode.
You have selected a paper
type that cannot be used for
duplex printing.
In [Tray Paper Settings], select a paper
type that can be used for duplex
printing. For details about the paper
types that can be used, see "Duplex
Copying", Copy/ Document Server
.
"Following output tray is full.
Remove paper." appears.
The output tray is full. Remove paper from the output tray to
resume printing. If paper is destined for
the finisher shift tray, to prevent paper
from falling off the tray press the [Stop]
key to suspend printing, and then
remove the paper. Press [Continue] on
the display panel to resume printing.
"Turn main Power Switch off"
appears.
The machine does not shut
down normally when the
main power switch is turned
off, and then immediately
turned on.
Turn off the machine. Wait for ten
seconds or more after shutting it down,
and then turn it on again.
When You Have Problems Operating the Machine
173