Message Status
"Setting change..." The machine is changing settings. You cannot use the control panel
while this message is displayed. Wait a while.
"Waiting for print data..." The machine is waiting for the next data to print. Wait a while.
"Suspending print jobs..." Printing was temporarily suspended because [Job Operation] or the
[Stop] key was pressed.
"Updating certificate..." The @Remote certificate is being updated. Wait a while.
Messages displayed on the control panel when using the printer function
• Before turning the main power switch off, see p.59 "Turning On/Off the Power".
Message Causes Solutions
"Cannot connect with the
wireless card. Turn the main
power switch off, then
check the card."
• The wireless LAN board
was not inserted when the
machine was turned on.
• The wireless LAN board
was pulled out after the
machine was turned on.
•
The settings are not
updated although the unit
is detected.
Turn off the main power switch, and
then confirm the wireless LAN board
is inserted correctly. And then, turn on
the main power switch again. If the
message appears again, contact your
service representative.
"Cannot connect with the
Bluetooth interface. Check
the Bluetooth interface."
• The Bluetooth interface
unit was installed while
the machine was turned
on.
• The Bluetooth interface
unit was removed while
the machine was turned
on.
Turn off the main power switch, and
then confirm that the Bluetooth
interface unit was installed correctly.
And then, turn on the main power
switch again. If the message appears
again, contact your service
representative.
"Hardware Problem:
Ethernet"
An error has occurred in the
Ethernet interface.
Turn off the main power switch, and
then back on again. If the message
appears again, contact your service
representative.
10. Troubleshooting
198
To Next Page
Loading...
Need help?
General
