4
Note
❒ Should the main power switch
of the machine be turned off be-
fore overwriting is completed,
the temporary data will remain
on the hard disk until the main
power switch is next turned on
and overwriting is resumed.
❒ If an error occurs before over-
writing is completed, turn off
the main power. Turn it on
again, and then repeat from step
A
.
❒ If the overwriting method is
changed while overwriting is in
progress, the remainder of the
temporary data will be over-
written using the method set
originally.
Canceling Auto Erase Memory
A
AA
A
Follow steps
A
AA
A
to
E
EE
E
in “Using
Auto Erase Memory”.
B
BB
B
Press [Off].
C
CC
C
Press [OK].
Auto Erase Memory is disabled.
Note
❒ To set Auto Erase Memory to
On again, repeat the procedure
in “Using Auto Erase Memory”.
To Next Page
Loading...
