Common Procedures
SM 3-25 J012/J013/J014
Replacement
Adjustment
Create a folder to hold the file or navigate to another target folder, enter a filename of
your choice or use the default filename "NewFile.dat" and save it.
4. Follow the procedure below to replace the scanner unit.
Preparation for Removal
Remove platen or ADF. ( 3.2.4, 3.2.5)
Raise the scanner unit to full upright. ( 3.2.7)
Remove: (1) paper cassette, (2) paper output tray, (3) right cover, (3) left cover
( 3.2.49, 3.2.10, 3.2.12)
1. At the left front corner of the machine, disconnect the scanner power cable harness[1]
CN4 from the PSU (x1).
2. Pull the harness out from behind the four L-clamps.
3. At the left rear corner of the machine, release the harness [2] from the white harness
clamps (=x3).
To Next Page
Loading...
