Boards
J012/J013/J014 3-38 SM
3.6 BOARDS
3.6.1 PSU
Preparation:
Remove platen or ADF. ( 3.2.4, 3.2.5)
Raise the scanner unit to full upright. ( 3.2.7)
Remove: (1) paper cassette, (2) paper output tray, (3) left cover ( 3.2.8, 3.2.12)
1. Disconnect the connectors [1] (x4).
2. Remove PSU board screws [2], [3], [4], [5] (x4).
A plastic corner cap is attached at [2]. Remove it from the machine if it falls off.
3. Release the tab [6] then remove the PSU.
To Next Page
Loading...
