SP Mode Service Tables
J012/J013/J014 5-50 SM
Suction Vents
1017 PRGPOS:R
Adjust Position of Right Suction Vent DFU
Use this SP to adjust the venting position of the right air vent. Do this SP after it
has been determined that the ink is not venting at the center of the right ink
suction vent.
[-128 to +128/FA/1/0.1 mm]
1018 PRGPORS:L
Adjust Position of Left Suction Vent DFU
Use this SP to adjust the venting position of the left ink suction vent. (Do this SP
after it has been determined that the ink is not venting at the center of the left ink
suction vent.
[-128 to +128/FA/1/0.1 mm]
Charge Width Setting Mj1: Simplex (DFU)
1100 CHG:W1:EDGE:1 LE/TE: Mj1: ID1
1102 CHG:W1:EDGE:2 LE/TE: Mj1: ID2
1104 CHG:W1:EDGE:3 LE/TE: Mj1: ID3
1106 CHG:W1:EDGE:4 LE/TE: Mj1: ID4
1101 CHG:W1:MIDLL:1 MIDLL: Mj1: ID1
1103 CHG:W1:MIDLL:2 MIDLL: Mj1: ID2
1105 CHG:W1:MIDL:3 MIDL: Mj1: ID3
1107 CHG:W1:MIDL:4 MIDL: Mj1: ID4
To Next Page
Loading...
