Ricoh J012 - Choosing a Location

Preparation
J012/J013/J014 1-2 SM
1.1.2 CHOOSING A LOCATION
1. Always install the machine:
 On a sturdy, level surface.
 Where it will not be exposed to either very low or very high humidity.
2. Make sure the machine is never exposed to:
 Extreme changes from low to high temperature or high to low temperature.
 Cold or cool air directly from an air conditioner.
 Heat from a space heater.
3. Never install the machine in areas near:
 Dust, lint, or corrosive fumes.
 Strong vibration.
4. Do not use the machine at any location higher than 2,000 m (6,500 ft) above sea level.
5. Set up and use the machine on a sturdy, level surface.
 Place a carpenter's level on the machine front-to-back, and side-to-side and confirm
that it is level.
 Variations between the front/back and left/right level readings should be less than 2
degrees.
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA