SP Mode Service Tables
SM 5-65 J012/J013/J014
Service
Tables
Set Maintenance Method
SP2115 to SP2118 are for future use and not used at the present time.
2115 TH:ALM:TM1:MNT1 After Time 1 Alarm (SP2111): Venting
2116 TH:ALM:TM1:MNT2 After Time 2 Alarm (SP2112): Cleaning
2117 TH:ALM:TM1:MNT3
After Time 3 Alarm (SP2113): Cleaning *
1
2118 TH:ALM:TM1:MNT4
After Time 4 Alarm (SP2114): Cleaning *
2
Use this SP to select the type of maintenance that will be executed before the first
print job begins after the idle time threshold has elapsed.
*
1
Air venting/filling is done if Bit 1 of SW8-3 is ON.
*
2
Print head refreshing (flushing) is done if Bit 2 of SW8-3 is ON.
[0 to 65535/0/1/hours.]
Note: These SP codes are not available for this machine.
Set Threshold for Venting During Printing
SP2200 to SP2202 are for future use and not used at the present time.
2200 TH:PRG:HUMI1 35% Humidity
2201 TH:PRG:HUMI2 65% Humidity
Use this SP to set the threshold value in the humidity table switches to the table
for air venting during printing.
SP2200: Looks up the low humidity table (35%).
SP2201: Looks up the high humidity table (65%).
[0 to 100/0/1/
o
C.]
To Next Page
Loading...
