Before You Begin
J012/J013/J014 5-4 SM
Fax No. Allows entry of the machine fax number.
Engine Maint.
Allows changing the settings of individual SP codes
(SP1000 to SP7532. For more about individual SP
code settings, refer to the tables in this section.
Note: There are no settings available for the
following groups: SP4000, SP6000, SP8000,
SP9000.
End
Select to leave the SP mode.
To exit SP mode
1. At any level in the SP mode press [No] to return to the first level.
SYSTEM Ver. 0.51
Service Menu
2. [#] or [%] > "End"> [Yes].
The machine leaves the SP mode and switches off.
3. Press [Power] to switch the machine on.
Using SP Mode Menus
Entering an Engine SP Code Directly
Do this procedure to enter an SP code directly if you know the number.
1. In the service tables of this section look up the number and name of the SP code to set.
Example: Set SP1164 HUMI:B for -2.5%
Calibrate Humidity Setting for Duplex
Range: [-128 to +127/0/1/0.1%]
2. [Clear Modes]> [1] [0] [7]> [Clear/Stop]
SYSTEM Ver. 0.51
Service Menu
3. [#] or [%] > "Engine Maint."> [Yes]
To Next Page
Loading...
