Ricoh J012 - Motors; Horizontal Motor

Motors
SM 3-45 J012/J013/J014
Replacement
Adjustment
3.7 MOTORS
3.7.1 HORIZONTAL MOTOR
Preparation:
 Remove platen or ADF. ( 3.2.4, 3.2.5)
 Raise the scanner unit to full upright. ( 3.2.7)
 Remove: (1) paper cassette, (2) paper output tray, (3) right cover, (4) left cover, (5)
scanner unit, (6) rear cover ( 3.2.8, 3.2.10, 3.2.12, 3.2.7, 3.2.15)
1. Gently (to avoid bending) push the leaf spring [1] to the right to release pressure on the
horizontal encoder strip, then disconnect both ends of the strip and remove it.
2. Remove screws [2] and [3].
3. At the rear corner of the printer, remove the horizontal motor [4] (x1).
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA