Options
SM 1-33 J012/J013/J014
Installation
An Ethernet cable is not provided with the machine. Select a proper cable for the
network environment.
1. Plug the Ethernet cable into the Ethernet port of the machine.
2. Connect the other end of the Ethernet cable to the network hub.
1 LED 1 Lights GREEN to indicate that the machine is properly connected to the
network.
2 LED 2 Lights RED to indicate that 100 Base-TX is operating, and remains off when
10 Base-TX is operating.
Do the Network Settings
Before doing this procedure ask the network administrator for the IP address.
1. If the machine is off, press [Power] to switch it on.
2. [Menu] > "System Settings?"
3. [#] or [%] > "Network Settings" > [Yes].
These are the settings on the Network Settings menu.
To Next Page
Loading...
