Boards
SM 3-41 J012/J013/J014
Replacement
Adjustment
6. Pull the NVRAM from the control board removed from the printer.
7. Install the NVRAM on the new control board.
8. Attach the NVRAM so the curvature of the white line on the board { matches the
curvature of the indentation | on the NVRAM chip. NOTE: The NVRAM can not be
replaced with a new one, see Technical Service Bulletin J012/J013/J014 – 021 NVRAM
CAN NOT BE REPLACED.
Rev. 09/09/2009
To Next Page
Loading...
