SM v J012/J013/J014
Suction Vents ..................................................................................... 5-50
Charge Width Setting Mj1: Simplex (DFU) ......................................... 5-50
Charge Width Setting Mj2: Simplex (DFU) ......................................... 5-51
Charge Width Setting Mj3: Simplex (DFU) ......................................... 5-51
Charge Width Setting Mj3: Simplex (DFU) ......................................... 5-51
Charge Width Setting Mj4: Simplex (DFU) ......................................... 5-52
Charge Width Setting Mj4: Simplex (DFU) ......................................... 5-52
Charge Width Setting Mj1: Duplex (DFU)........................................... 5-52
Charge Width Setting Mj2: Duplex (DFU)........................................... 5-53
Charge Width Setting Mj3: Duplex (DFU)........................................... 5-53
Charge Width Setting Mj4: Duplex (DFU)........................................... 5-54
Calibrate Humidity/Temperature for Duplex ....................................... 5-54
Charge ID Tables: Mj1 ....................................................................... 5-55
Charge ID Tables: Mj2 ....................................................................... 5-56
Charge ID Tables: Mj3 ....................................................................... 5-57
Charge ID Tables: Mj4 ....................................................................... 5-57
Set Charge Area 1.............................................................................. 5-58
Set Charge Area 2.............................................................................. 5-59
Set Charge for Target Market............................................................. 5-60
Print Head Temperature Thresholds .................................................. 5-61
Ambient Temperature Thresholds ...................................................... 5-61
5.3.3 GROUP 2000.................................................................................. 5-62
Set Threshold for Near-Full Alert........................................................ 5-62
Set Threshold for Automatic Print Head Cleaning .............................. 5-63
Set Threshold Idle Time for Maintenance Alarm ................................ 5-64
Set Maintenance Method ................................................................... 5-65
Set Threshold for Venting During Printing .......................................... 5-65
5.3.4 GROUP 3000.................................................................................. 5-67
Adjust Printhead Gap for dpi .............................................................. 5-67
Set Print Head Rank (Wave) .............................................................. 5-68
Set Print Head Rank (Voltage) ........................................................... 5-68
Set Amount for Standard Ink Coverage.............................................. 5-69
Gamma: K, C, M, Y ............................................................................ 5-69
5.3.5 GROUP 4000.................................................................................. 5-69
5.3.6 GROUP 5000.................................................................................. 5-70
Reset and Restoration Settings.......................................................... 5-70
Firmware Upload, Download .............................................................. 5-70
Maintenance, Replacement................................................................ 5-71
Input Check: Sensors 1/2 ................................................................... 5-74
Input Check: Sensors 2/2 ................................................................... 5-75
Input Check: Temperature and Humidity............................................ 5-75
Input Check: Air.................................................................................. 5-76
Input Check: Ink Cartridge Set Sensors ............................................. 5-76
Input Check: Ink Cartridge Levels ...................................................... 5-77
Input Check: Ink Collector Unit Sensor............................................... 5-77
Encoder Readings.............................................................................. 5-78
Board Temperature Sensors .............................................................. 5-78
To Next Page
Loading...
