SC Error Codes
J012/J013/J014 4-38 SM
Code Possible Cause
0021 File full.
0022
Correct data not received within specified time due to noise interference on the
line.
0023 Received PWD error in RSD or upgrade firmware.
0029 Mailbox password not set or password mismatch for mailbox receiving.
0030 No signal received within 6 sec. at phase D.
0031
Received incorrect signal at phase D (not EOP, MPS,EOM,DCS PPS_Q,
PPS_Q, etc).
0032 No carrier received within 6 sec. after sending MCF, RTP, or RTN signal.
0033 Received DCN signal at phase D between pages (not last page) .
0039
Data received in non-ECM mode but did not receive next line within 13.1
seconds.
003F Remote machine TSI not defined for one touch or speed dial directory.
0040 No carrier signal received within 6 sec. after sending CTR.
0041 No carrier signal within 6 sec. after sending PPR.
0042 No correct signal received after sending RNR signal.
0043 Received incorrect signal at phase D in ECM mode.
0044 No carrier /FSK signal received within 6 sec. after sending MCF in ECM mode.
0047 No correct signal received after sending ERR signal.
0048 No correct signal received after receive PPS_PRI_Q. PRI_Q, orEOR_PRI_Q .
004A
Line power over threshold for 60 sec. after MCF. No FSK or carrier signal
detected in ECM mode.
004B Correct FSK signal not detected even though FSK tone detected within 6 sec.
004C Handshake failed during re-training or between page during V34 RX.
To Next Page
Loading...
