SC Error Codes
SM 4-41 J012/J013/J014
Trouble-
shooting
Code Possible Cause
document because it was out of paper, or for some other reason.
008F
Modem was not ready to receive V.34 data within 6 sec. after it received CFR
signal.
0090 Remote machine not ready for document polling.
0091 DCS+TCF signal sent 3 times but no response signal in response.
0093 DCN signal received after DCS signal sent for V.34
0094 Time-out during ECM frame or RCP command transmission.
0095 Wrong ID number for polling RX or mailbox TX.
0096 Sub-address or password mismatch in polling RX mode.
009A No signal detected after CI signal sent.
009D
Remote machine hung up before V.34 modem entered Phase 2 during V.34
polling RX.
009E Manual TX over 15 min. in Phase C of non-ECM mode.
00A0 Operator stopped or cancelled TX job.
00A1 Document jammed during transmission
00AE
V.8 procedure did not complete, or no V.21 signal detected after CM signal
within 30 sec.
00AF Modem did not enter control channel after TX side sent RCP signal for V.34
00B1
V.8 procedure did not complete, or V.21 signal not detected after ANSAM
signal within 35 sec.
00B2 Phase 2 signal not detected within 30 sec. after local machine sent CJ signal.
00B3 V.21 or JM signal not detected after CM signal was sent.
00B4 No Phase 2 signal detected within 25 sec. after CM/JM signal exchange.
00B5 No Phase 3 signal detected within 25 sec. after Phase 2.
To Next Page
Loading...
