Due to this function the original images similar to bank bills may not be copied properly.
Some illustrations in this manual might be slightly different from the machine.
For good print quality, the supplier recommends that you use genuine print
cartridges from the supplier.
The supplier shall not be responsible for any damage or expense that might result
from the use of parts other than genuine parts from the supplier with your office
products.
Power Source
220-240 V or more, 50 / 60 Hz, A or more
Voltage must not fluctuate more than 10%.
Please be sure to connect the power cable to a power source as above.
Confirm that the wall outlet is near the machine and freely accessible, so that in event of
an emergency, it can be un-plugged easily.
Disconnect the power plug (by pulling the plug, not the cable) if the power cable or
plug becomes frayed or otherwise damaged.
The supplied power cord is for use with this equipment only. Do not use with other
appliances. Doing so may result in fire, electric shock, or injury.
Connect the machine only to the power source described on the inside front cover
of this manual. Connect the power cord directly into a wall outlet and do not use an
extension cord.
Avoid multi-wiring.
Do not damage, break or make any modifications to the power cord. Do not place
heavy objects on it. Do not pull it hard nor bend it more than necessary. These
actions could cause an electric shock or fire.
Do not plug or unplug the power cord with your hands wet. Otherwise, an electric
shock might occur.
To avoid hazardous electric shock, do not remove any covers or screws other than
those specified in this manual. When the machine needs to be checked, adjusted,
or repaired, contact your service representative.
Do not take apart or attempt any modifications to this machine. There is a risk of fire,
electric shock, explosion or loss of sight. If by any chance this machine falls over or
a breakage occurs (e.g. the cover), turn off the main switch, unplug the power cable
and contact your service representative. If you continue to use the machine in this
state it could result in fire or electric shock.
To Next Page
Loading...
