Before Replacing Parts
SM 3-7 J012/J013/J014
Replacement
Adjustment
To remove: First, remove in this order:
Cleaning – Horizontal Encoder
Strip
1) Platen or ADF., 2) Scanner to Full Upright
Cleaning – Maintenance Unit
1) [Menu]> #> "Maintenance"> [Yes}> "1 Nozzle
Check?"> #> "9 Move Print Heads?"> [Yes]> "Please
Wait", 2) Open scanner unit
Cleaning – Transport Belt 1) Platen or ADF., 2) Scanner to Full Upright, 3) `Paper
Cassette, Output Tray, 4) Duplex Unit, 5) Flushing Gate
Duplex Unit ---
Duplex Unit Detection Board 1) Platen or ADF., 2) Scanner to Full Upright, 3) Paper
Cassette, Output Tray, 3) Right Cover, 4) Left Cover, 5)
Scanner Unit, 6) Rear Cover
Flushing Unit 1) Platen or ADF., 2) Scanner to Full Upright, 3) Left
Cover
Front Cover 1) Platen or ADF., 2) Scanner to Full Upright, 3) Paper
Cassette, Output Tray, 4) Right Cover, 5) Right Inner
Cover, 6) Left Cover
Front Fan 1) Platen or ADF., 2) Scanner to Full Upright, 3) Paper
Cassette, Output Tray, 4) Right Front Cover, 5) Right
Cover
HVPS 1) Platen or ADF., 2) Scanner to Full Upright, 2) Paper
Cassette, Output Tray, 3) Left Cover, 4) Right Cover, 5)
Front Cover
Horizontal Encoder Strip 1) Platen or ADF., 2) Scanner to Full Upright, 3)
Scanner Unit, 4) Left Cover, 5) Right Cover, 6) Rear
Cover
Horizontal Motor 1) Platen or ADF., 2) Scanner to Full Upright, 3)Paper
Cassette, Output Tray, 4) Right Cover, 5) Left Cover, 6)
Scanner Unit, 7) Rear Cover
To Next Page
Loading...
