• Tray to Program
• Tray 1
• Tray 2
• Tray 3
• Tray 4
• Tray 5
• Tray 6
• Tray 7
• Tray 8
• Tray A
• Intpsr. Upper (when the interposer is installed.)
• Intpsr. Lower (when the interposer is installed.)
Default: Off (Tray is not specified.)
• Apply Duplex
• Yes
• No
Default: [Yes]
• Display Time
• At Mode Selected
• Full Time
Default: [At Mode Selected]
• When you select an interposer tray, you cannot change the [Display Time] and [Apply
Duplex] settings.
• When [At Mode Selected] is selected for [Display Time], the [Desig. Sheet 1–11] settings only
appear when the designation sheet function is selected.
• You can specify the [Apply Duplex] settings only when [At Mode Selected] is selected for
[Display Time].
• The lock mark ( ) is displayed next to the paper tray when [Full Time] is selected for [Display
Time].
Changing Tray Paper Settings
261
To Next Page
Loading...
