3. Press the [Start] key.
4. Select the file format by pressing the corresponding selection key.
If the [Limitless Scan] setting under [Scan Settings] is enabled, you may see the following
screen on the display when scanning from the exposure glass.
If you see this screen, proceed to the next step.
5. If you have more originals to scan, place the next original on the exposure glass,
and then press [Yes]. Repeat this step until all originals are scanned.
6. When all originals have been scanned, press [No] to start sending the scanned file.
7. Wait until "Completed the Process" is displayed on the screen.
Scanned files are saved in the root directory of the USB flash memory device.
8. Remove the USB flash memory device from the machine.
• To cancel scanning, press the [Clear/Stop] key. The scan files are discarded.
• You can configure the machine to perform black-and-white scanning in halftone or grayscale by
changing [Scanning Mode] setting under the scan settings. For details about [Scanning Mode], see
page 244 "Scanner Features Settings (When Using the Touch Panel Model)" or page 292
"Scanner Features Settings (When Using the Four-line LCD Panel Model)".
• If the [Limitless Scan] setting under the scan settings is enabled, you can place originals on the
exposure glass repeatedly in a single scan procedure. For details about [Limitless Scan], see
page 244 "Scanner Features Settings (When Using the Touch Panel Model)" or page 292
"Scanner Features Settings (When Using the Four-line LCD Panel Model)".
Basic Procedures for Saving Scan Files on a USB Flash Memory Device
173
To Next Page
Loading...
