This equipment is not capable, under all operating conditions, of correct operation at the higher speeds
for which it is designed. Telecom will accept no responsibility should difficulties arise in such
circumstances.
Devices connected to the telephone port may lose their memory if this fax machine is on line for
extended periods. To prevent this, such devices should have the facility for battery or similar backup of
memory.
This device may be subject to ringing or bell tinkle when certain other devices are connected to the same
line. If this occurs, the problem should not be referred to the Telecom Faults Service.
This equipment should not be used under any circumstances that may constitute a nuisance to other
Telecom customers.
Telepermitted equipment only may be connected to the auxiliary telephone port. The auxiliary telephone
port is not specifically designed for 3-wire connected equipment that may not respond to incoming
ringing when attached to this port.
Notes to users in the state of California (Notes to Users in USA)
Perchlorate Material - special handling may apply. See: www.dtsc.ca.gov/hazardouswaste/
perchlorate
Notes to users in the United States of America
Part 15 of the FCC Rules
Note:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio /TV technician for help.
Information for This Machine
475
To Next Page
Loading...
Need help?
General
Weight and Dimensions
