Ricoh SP 3710SF - When You Cannot Make Copies as Wanted

Problem Solution
When copying from the exposure
glass, the print area of the copy is
out of alignment with the original.
Place the original copy side down, making sure that it is
aligned to the rear left corner and pressed flat against the
exposure glass.
When You Cannot Make Copies as Wanted
Problem Solution
Photocopied pages are not in
correct order.
When Using the Touch Panel Model
On the control panel, change the [Sort] setting under copy
settings to collate pages as you require. For details about
[Sort], see page 239 "Copier Features Settings (When Using
the Touch Panel Model)".
When Using the Four-line LCD Panel Model
On the control panel, change the [Sort] setting under copy
settings to collate pages as you require. For details about
[Sort], see page 287 "Copier Features Settings (When Using
the Four-line LCD Panel Model)".
Copied pages are too dark or too
light.
Adjust the image density. See page 135 "Adjusting Image
Density".
10. Troubleshooting
430