When Paper Is Not Fed or Ejected Properly
Problem Solution
Prints fall in front of the machine
when they are output.
Raise the stop fence. For the position of the stop fence, see
page 19 "Guide to Components".
Prints do not stack properly. The paper being used may be damp. Use paper that has been
stored properly. See page 74 "Supported Paper".
The printed paper is curled. • Load the paper upside down in the paper tray.
• If the paper curl is severe, retrieve prints from the output
tray more frequently.
• The paper being used may be damp. Use paper that has
been stored properly.
• If you enable [Toner Saving] under [System Settings],
printing is generally less dense.
Printed envelopes come out creased. Check if the fusing unit levers are properly set. Lower the fusing
unit levers.
Other Printing Problems
Problem Solution
The toner has run out and printing
has stopped.
• When Using the Touch Panel Model
When the "Continue printing?" message appears on the
control panel, pressing [Yes] allows you to print a few
more pages, but the print quality of those pages may be
lower.
• When Using the Four-line LCD Panel Model
When the "Continue printing?" message appears on the
control panel, pressing the [OK] key allows you to print a
few more pages, but the print quality of those pages may
be lower.
10. Troubleshooting
428
To Next Page
Loading...
