Ricoh SP 3710SF - Entering Characters (When Using the Four-Line LCD Panel Model)

Entering Characters (When Using the Four-line
LCD Panel Model)
This description is for SP 330SN only.
To enter characters, use keys as follows:
To enter a digit
Press a number key.
To delete a character
Press the [
] key.
To enter a name
Letters, numbers, and symbols can be entered using the number keys.
To enter two characters consecutively that use the same number key, press the [ ] key to move the
cursor before entering the second character.
DSG155
• Characters you can enter depend on the setting you are configuring.
• If the number you entered is too large or too small for the setting, it will not be accepted. If you
press the [OK] key, the machine will increase or decrease the number to the minimum or maximum
value for the setting.
Entering Characters (When Using the Four-line LCD Panel Model)
49