Item Description Value
Auto Reduction Sets the machine to reduce the size of
a received fax if it is too large to print
on a single sheet of paper.
Note that the machine only reduces
the size down to 74%. If further
reduction is required to fit the fax on a
single sheet, it will be printed on
separate sheets without being
reduced.
• Off
• On
Default: [On]
Default may be [Off] depending on
the [Country] setting under
[Administrator Tools].
No. of Rings
(TAD)
Specifies the number of times the
external telephone answering device
rings before the machine starts to
receive faxes in FAX/TAD mode.
1 to 20 times, in increments of 1
Default: 5 times
Number of
Rings
Specifies the number of times the
machine rings before it starts to receive
faxes in Fax Only mode.
3 to 5 times
Default: 3 times
RX Mode
Switch Time
Specifies how long the machine rings
before it starts to receive faxes in FAX/
TEL(Auto) mode.
5 to 99 seconds
Default: 15 seconds
Receive
Conditions
Specifies whether to receive or reject
faxes from the programmed Special
Senders.
• All Senders
Receive faxes from all senders.
• Special Sender
Receive faxes from the Special
Senders and reject faxes from
all other senders.
• Not Special Sender
Reject faxes from the Special
Senders and receive faxes from
all other senders.
Default: [All Senders]
Duplex Print Specify whether or not received fax
documents are to be printed on both
sides of the paper.
• Off
• Duplex Portrait: T to T
• Duplex Portrait: T to B
Default: [Off]
7. Configuring the Machine Using the Control Panel
248
To Next Page
Loading...
