Printer Registration
Adjust the registration of each tray if necessary. You can adjust the registration value between -15
and +15 (that is, -1.5 and +1.5 mm, in 0.1 mm increments).
Default: 0 for all parameters
Item Description
Horiz.: Tray 1 Select this to adjust the tray 1 registration horizontally.
Horiz.: Tray 2 Select this to adjust the tray 2 registration horizontally.
Vert.: Tray 1 Select this to adjust the tray 1 registration vertically.
Vert.: Tray 2 Select this to adjust the tray 2 registration vertically.
Horiz.: Bypass
Tray
Select this to adjust the bypass tray registration horizontally.
Vert.: Bypass
Tray
Select this to adjust the bypass tray registration vertically.
Horiz.: Duplex
Unit
Select this to adjust the registration of the back of duplex printing horizontally.
Vert.: Duplex
Unit
Select this to adjust the registration of the back of duplex printing vertically.
Low Humidity Mode
Item Description Value
Low Humidity
Mode
If the machine is used in a room where
humidity level is low, black lines of a
few millimeters thick may appear on
printouts with 75-millimeter spaces in
between. Selecting [On] for this setting
may prevent these lines from
appearing (wait for about one day
until this setting becomes effective).
Note that when this setting is enabled,
the machine automatically performs
self-maintenance in every 10 minutes.
• Off
• On
Default: [Off]
7. Configuring the Machine Using the Control Panel
260
To Next Page
Loading...
