Auto Continue
Item Description Value
Auto Continue Sets the machine to ignore an error
with paper size or type and continue
printing. The printing stops temporarily
when an error is detected, and restarts
automatically after about ten seconds
using the settings made on the control
panel.
However, if the size of paper specified
on the control panel and that of the
paper loaded in the paper tray or the
paper size specified for the print job
do not match when printing restarts, it
may cause a paper jam.
• Off
• On
Default: [Off]
Toner Saving
Item Description Value
Toner Saving Sets the machine to print using a
reduced amount of toner (for prints
made by the copier function only).
• Off
• On
Default: [Off]
Supplies Status
Displays information about consumables.
Item Description Value
Print Cart. Displays the remaining amount of
supplies.
• (New)
•
•
•
•
• (Needs replacing)
Printer Registration
Adjust the registration of each tray if necessary. You can adjust the registration value between -15
and +15 (that is, -1.5 and +1.5 mm, in 0.1 mm increments).
7. Configuring the Machine Using the Control Panel
296
To Next Page
Loading...
