8. PARAMETER DESCRIPTION
IMR02C15-E4
8-54
îš„ When Output limiter high [oLH] is changed
The following parameter will be automatically converted.
• Manual manipulated output value (MV) • Output limiter low
îš„ When Output limiter low [oLL] is changed
The following parameter will be automatically converted.
• Manual manipulated output value (MV) • Output limiter high
îš„ When Decimal point position (PGdP) is changed
The following parameter will be automatically converted.
• Input scale high • Event 1 set value (EV1’) [low]
• Input scale low • Event 1 differential gap
• Setting limiter high • Event 2 set value (EV2)
• Setting limiter low • Event 2 set value (EV2) [high]
• Set value 1 (SV1) • Event 2 set value (EV2’) [low]
• Set value 2 (SV2) • Event 2 differential gap
• Set value 3 (SV3) • Event 3 set value (EV3)
• Set value 4 (SV4) • Event 3 set value (EV3) [high]
• Setting change rate limiter (up) • Event 3set value (EV3’) [low]
• Setting change rate limiter (down) • Event 3 differential gap
• Proportional band [heat-side] • Event 4 set value (EV4)
• Overlap/Deadband • Event 4 set value (EV4) [high]
• PV bias • Event 4 set value (EV4’) [low]
• LBA deadband (LBD) • Event 4 differential gap
• Event 1 set value (EV1) • Transmission output scale high
• Event 1 set value (EV1) [high] • Transmission output scale low
îš„ When Input scale high (PGSH) is changed
The following parameter will be automatically converted.
• Input scale low • Event 2 set value (EV2)
• Setting limiter high • Event 2 set value (EV2) [high]
• Setting limiter low • Event 2 set value (EV2’) [low]
• Set value 1 (SV1) • Event 2 differential gap
• Set value 2 (SV2) • Event 3 set value (EV3)
• Set value 3 (SV3) • Event 3set value (EV3) [high]
• Set value 4 (SV4) • Event 3 set value (EV3’) [low]
• Setting change rate limiter (up) • Event 3 differential gap
• Setting change rate limiter (down) • Event 4 set value (EV4)
• Proportional band [heat-side] • Event 4 set value (EV4) [high]
• LBA deadband (LBD) • Event 4 set value (EV4’) [low]
• Event 1 set value (EV1) • Event 4 differential gap
• Event 1 set value (EV1) [high] • Transmission output scale high
• Event 1 set value (EV1’) [low] • Transmission output scale low
• Event 1 differential gap
To Next Page
Loading...
Need help?
General
