6. OPERATIONS OF THE BASIC FUNCTIONS
IMR02C15-E4
6-25
Set lock level of Parameter setting mode
The same parameters exist in Engineering mode, grouped by group number (F01 to F10) as shown
below. In the Set lock level (LocK) screen, you can lock the group number that contains the
parameter(s) that you wish to lock, and this will lock the same parameters in Parameter setting mode.
After Set lock level is stored, data lock will be effective by setting Set data unlock/lock transfer in
Mode switching to “lock.”
Set lock level (: Locked data)
Engineering mode (Set lock level [LocK])
No.*
Parameter setting mode
0123456 7 8 910
F01 Set value 1 (SV1) to Set value 4 (SV4)
SV selection
F02 Timer 1 to Timer 4
Timer function
Repeat execution time
F03 Setting change rate limiter (up)
Setting change rate limiter (down)
F04 Event 1 set value (EV1)
Event 1 set value (EV1) [high]
Event 1 set value (EV1′) [low]
Event 2 set value (EV2)
Event 2 set value (EV2) [high]
Event 2 set value (EV2′) [low]
Event 3 set value (EV3)
Event 3 set value (EV3) [high]
Event 3 set value (EV3′) [low]
Event 4 set value (EV4)
Event 4 set value (EV4) [high]
Event 4 set value (EV4′) [low]
F05 Autotuning (AT)
Startup tuning (ST)
F06 Proportional band [heat-side]
Integral time
Derivative time
Anti-reset windup (ARW)
Proportional band [cool-side]
Overlap/Deadband
Fine tuning setting
F07 Heater break alarm 1 (HBA1) set value
Heater break alarm 2 (HBA2) set value
Control loop break alarm (LBA) time
LBA deadband (LBD)
F08 Proportional cycle time [heat-side]
Minimum ON/OFF time of proportioning cycle [heat-side]
Output limiter high [Heat-side output limiter (high)]
Output limiter low [Cool-side output limiter (high)]
Proportional cycle time [cool-side]
Minimum ON/OFF time of proportioning cycle [cool-side]
F09 PV bias
PV digital filter
F10 Manual manipulated output value (MV)
All settings unlocked (Factory set value)
* F01 to F10 indicate group numbers used in Set lock level in Engineering mode.
To Next Page
Loading...
