Robopac S6 - Page 18

ROBOT S6
‒ Single wrapping: It starts at the base of
the pallet with a series of stabilizing
windings and then stops at the top of the
pallet with a closing winding.
To start a new wrapping phase from the
base, the roll-holder carriage must be
lowered using the manual controls.
1) Start
2) STOP
‒ Double wrapping: the base of the pallet
with a series of stabilizing windings and
then reaches the top of the pallet.
After performing a reinforcement
winding at the top, the wrapping process
continues back to the bottom and stops
after performing the closing winding.
1) Start
STOP
‒ Double wrapping with sheet feeder: It
starts at the base of the pallet with a
series of stabilizing windings and
temporarily stops at the top of the pallet.
After the protection sheet (TOP) has
been put in place, the Operator resumes
the wrapping cycle.
After performing a reinforcement
winding at the top, the wrapping process
continues back to the bottom and stops
after performing the closing winding.
1) Start
STOP
2) Start
STOP
18/94