Robopac S6 - Safety Warning for Electrical Equipment; Information and Safety Signals

ROBOT S6
‒ Replace the components ONLY with ORIGINAL PARE PARTS or with SIMILAR design and functional
features.
T
he use of similar but non-original spare parts may lead to improper repairs, altered performance and
economic damage.
T
he components and/or safety devices shall be replaces ONLY with original spare parts t
o
avoid alterin
g
the
p
rovided safet
y
level.
‒ Use lubricants (oils or grease) recommended by the manufacturer or with similar chemical-physical
features.
‒ Do not dump into the environment polluting liquids, worn parts and maintenance waste.
‒ Select the components according to the chemical and physical features of the material and carry out
the differentiated waste disposal as per the standards in force.
‒ All the extraordinary maintenance interventions shall be carried out EXCLUSIVELY by authorised
personnel with particular expertise in the field of intervention.
Non compliance with the instructions given may cause risks for safety and health of the
p
ersons and economic dama
g
es.
2.7. SAFETY WARNING FOR ELECTRICAL EQUIPMENT
T
he electrical s
y
stem has been desi
g
ned and built in com
p
liance with a
pp
licable le
g
islation.
T
his legislation also specifies the ambient conditions required for operation.
T
he followin
g
list s
p
ecifies ambient conditions necessar
y
to ensure correct electrical s
y
stem function.
―
Ambient temperature must be between 5°C°C and 40°C.
―
Relative humidity must be between 50% (measured at 40°C) and 90% (measured at 20°C).
―
The installation area must not be subject to or contain sources of electromagnetic interference or
radiation (X rays, laser light etc).
―
The installation area must not contain potentially explosive or flammable mixtures of gases or dust.
―
No contaminant or corrosive products (acids, chemicals, salts etc.) may be used during production and
maintenance. Any products used must be kept away from electrical components.
―
The ambient temperature during storage must be between - 25°C and 55°C.
―
Electrical equipment may be exposed to temperatures up 70°C, provided that exposure does not
exceed 24 hours.
―
The electrical system will function correctly up to an altitude of 1000 m above sea level.
If any of the aforementioned conditions cannot be met, any additional measures necessary to
ensure safe operating conditions (e.g. special electrical components, air conditioning systems
etc.) must be defined durin
g
the contractual sta
g
e.
2.8. INFORMATION AND SAFETY SIGNALS
T
he fi
g
ure indicates the
p
osition of the safet
y
and information si
g
ns affixed to the machine.
12/94