Robopac S6 - Maintenance Information; Maintenance Instructions; Maintenance Period Table

ROBOT S6
7. MAINTENANCE INFORMATION
7.1. MAINTENANCE INSTRUCTIONS
‒ A good maintenance will allow for a longer working life and constant compliance with the
safety requirements.
‒ Before performing any operation, the authorised operator must make sure that he/she
understood the "Instructions for use".
‒ Pay attention to the SAFETY WARNINGS, do not use the machine for UNSPECIFIED
PURPOSES and assess the possible RESIDUAL RISKS.
‒ Carry out the interventions with all the safety devices enabled and wear the DPI provided.
‒ Mark the intervention area and prevent access to the devices that, if activated, may cause
unexpected hazards and jeopardize the safety level.
‒ DO NOT carry out any intervention that is not described in the manual but contact an
Assistance Service authorised by the manufacturer.
‒ DO NOT damp in the environment materials, pollutant liquids and the residues created
durin
g
the interventions but dis
p
ose them accordin
g
to the standards in force.
7.2. MAINTENANCE PERIOD TABLE
T
he table below specifies the routine maintenance intervals to be followed to ensure top performances,
a
longer working life and constant compliance with the safety requirements.
Frequency Component Type of
intervention
Procedure Reference
Every 40 hours or
1000 cycles
∗
Machine operating
areas
Cleaning Use a cloth
or
compressed
air
-
Every 200 hours
or 5000 cycles
∗
Rubber coated
rollers
Cleaning Use a cloth
dampened
with alcohol
-
Every 200 hours
or 5000 cycles
∗
Reel carriage Lubricate - See “Lubrication
point diagram”
Every 200 hours
or 5000 cycles
∗
Reel carriage Check chain
slack
- See “Reel
carriage lifting
chain adjustment”
Every 200 hours
or 5000 cycles
∗
Reduction gears
and gearmotors
Check
lubricant
level ¹
Top up, if
necessary
See “Lubrication
point diagram”
Every 2000 hours
or 10000 cycles
∗
Reel carriage Check chain
wear
Replace
chain, if
worn out
Contact the
Technical Service
authorized by the
Manufacturer
Every 2000 hours
or 10000 cycles
∗
Inductive sensors Check
efficiency
Adjust the
distance
between the
stops (2 mm)
-
Every 2000 hours
or 10000 cycles
∗
Safety devices Check
efficiency
Have any
faulty
device
replaced
Contact the
Technical Service
authorized by the
Manufacturer
58/94