ROBOT S6
2. SAFETY INFORMATION
2.1. GENERAL SAFETY PRECAUTIONS
‒ Carefully read the "Instructions for use" specified in the manual and those applied directly to the
machine.
It is important to dedicate a little time to read the "Instructions for use" in order to minimise the risks
and avoid unpleasant accidents.
‒ Before performing any operation, the operator must make sure that he/she understood the "Instructions
for use".
‒ Pay attention to the SAFETY WARNINGS, do not use the machine for UNSPECIFIED PURPOSES and assess
the possible RESIDUAL RISKS.
‒ Caution is essential.
Safety is also in the hands of those who interface with the machine throughout its life span.
Sometimes, accidents can be caused b
a "careless" use of the machine b
the o
erator.
Usually it is too late to remember what should have been done when the accident has
alread
ha
ened.
‒ Preserve the readability of the information signs and observe the indications given.
he information signs may have different shapes and colours, indicating hazards, obligations
prohibitions and information.
‒ The manufacturer has designed the machine observing all the "good manufacturing regulations" and
the standards in force.
he machine has been designed to be constructed and equipped with devices that ensure intrinsi
safety.
ampering with the safety devices and the removal of the same may create risks (even severe) for the
operators.
‒ The personnel authorised to carry out any operation with the machine must have acknowledged
experience in the specific field.
‒ The manufacturer is not responsible for any damage to the product delivered in the package
durin
the wra
in
and stabilisation and the followin
o
eration
hases.
Non compliance with the instructions given may cause risks for safety and health of the
ersons and economic dama
es.
2.2. SAFETY WARNINGS FOR HANDLING AND INSTALLATION
‒ The personnel authorised to handle the machine (loading and unloading) must possess particular
expertise in the field of intervention.
‒ Handle (load and unload) the machine according to the instructions affixed directly to the machine, to
the package and those in the user manual.
‒ During handling use one or two assistants, if required. This operation may generate unpredictable risks.
In order to minimise the risks related to assistants' involvement, you must inform them priorily on the
type of work and the behaviour to be used.
‒ The machine must be handled with the aid of specific means (crane, forklift etc.) by qualified personnel
capable of observing the safety requirements.
‒ When using the lifting means, insert and/or fasten the devices (hooks, forks etc.) ONLY into the points
provided on the package and/or the machine.
‒ Transport the machine suitable means of adequate capacity.
‒ Make sure the machine and its components are properly fastened to the transport mean.
Check the machine dimensions and affix proper signs if the machine overall dimensions exceed the
values allowed by road regulations.
‒ The minimum and maximum temperature (during transport and/or storage) must fall within the range
allowed in order to prevent damaging the electrical components.
To Next Page
Loading...
