Robopac S6 - Page 49

ROBOT S6
A
) Area: It displays the name of the set of
parameters being programmed.
B) Area: displays the preview of the pallet
wrapping cycle selected.
C) Push-button: used to select the type of
wrapping cycle of the pallet.
At each activation, the push-button
displays the function enabled with the
reference icon:
‒ Icon C1: used to select the "Single
wrapping " cycle.
‒ Icon C2: used to select the "Double
wrapping" cycle.
‒ Icon C3: used to select the "Double
wrapping cycle with sheet feeder".
D) Push-button: used to select the stop
mode (automatic or programmed) of the
spool carriage during lifting.
At each activation, the push-button
displays the function enabled with the
reference icon.
‒ Icon D1: used to select the automatic stop of the spool carriage (lifting phase) depending on the
height of the pallet being wrapped.
‒ Icon D2: used to select the programmed stopping of the spool carriage (lifting phase) depending
on the height of the pallet.
E) Push-button: used to program the delay time of the stopping point of the spool carriage during lifting
(automatic or programmed stopping).
F) Push-button: used to enable and disable the programming of the distance from the ground (offset) for
wrapping start.
‒ Blue background: The function is enabled.
‒ Gray background: The function is disabled.
G) Push-button: used to program the distance from the ground (offset) for wrapping start.
The push-button is only visible if the function was enabled through the button (F).
H) Push-button: used to enable and disable the programming of reinforcement wrapping.
‒ Blue background: The function is enabled.
‒ Gray background: The function is disabled.
L) Push-button: used to program the positioning height and the number of reinforcement wrapping.
The push-buttons are only visible if the function was enabled through the button (H).
M) Button: it shows the "Wrapping with special cycles" screen.
N) Push-button: used to enable/disable the cutting.
O) Push-button: used to enable and disable the programming of the cycle with creasing device.
‒ Blue background: The function is enabled.
‒ Gray background: The function is disabled.
49/94