Roche Cedex Bio - Page 550

Roche Diagnostics
G-16
Operator’s Manual · Version 3.4
Index Cedex Bio analyzer
ISE results, C–35
– calculation checks, C–35
– calculation of concentration, C–35
ISE status, screen, A–97
ISE tower, F–11
– cleaning automatically, F–54
– cleaning manually, F–55
– cleaning off the analyzer, F–40
ISE unit, F–9
– deactivating, F–68
–main components, F–10
– specifications, A–66
K
keyboards, A–75
L
laboratory conversion, C–28
laboratory correlations, B–166
layout of screens, A–70
LEDs
– color table, A–126
– ISE, F–10
–overview, A–41
level detection, A–49
lids
–ISE, F–9
–overview, A–39
linear interpolation, C–17
linear regression, C–18
lists
– Abs. flags, E–28
– alarm messages, E–10
– expanding and collapsing, A–74
– ISE flags, F–75
– lots, A–109
– orders, A–101
loading
– reagent disk, B–23, E–50
– reagents, B–28
loadlist, screen, A–110
log files, exporting, B–120
logging off, B–96
logging on, B–12
logit/log 4, C–19
logit/log 5, C–20
logs, alarm messages, E–9
lot data, screen, A–108
lot list, A–109
lots
– adding, B–110
– defining, B–110
– defining for calibrators, B–160
– defining for controls, B–159
– handling, B–106
– list, A–109
– viewing definitions, B–106, B–107
– viewing details of used fluids, B–109
lower-case letters, A–76
M
main calibration, F–12, F–28
maintenance
–analyzer, D–5
– ISE, F–43
–overview, D–5
– screen, A–114
maintenance actions
– Abs. air/water calibration, D–26
– Activate electrodes, F–49
– Clean housing, D–20
– Clean ISE tower automatically, F–54
– Clean ISE tower manually, F–55
–Clean probe manually, D–12
–Clean reagent disk, D–14
– Clean rotor and heating channel, D–10
– Clean rotor heating channel, D–29
– Clean water and waste, D–16
– Cleanup database, D–21
– colors of entries, B–22
– Condition ISE tubing, F–50
– Contact service representative, D–25
– Daily prepare actions, F–48
– Deproteinize probe, D–10
– Electrode service, F–53
– Initialize ISE reference sensor, F–51
– Initialize ISE unit, F–57
– intervals, D–7
– intervals for ISE, F–45
–performing, D–6
– performing during End Shift phase, B–93
– performing during Prepare phase, B–21
–Prime fluid system, D–11
– Prime ISE calibrator and reference, F–52
– Replace ISE pump tubing, F–58
– Replace ISE unit tubing, F–61
– Replace photometer lamp, D–22
– Replace water inlet filter, D–18
maintenance days, B–181
manual, how to use, 7
mapping, application codes, B–174
mean rate, calculation, C–16
measurement principles, C–3