Roche Cedex Bio - Page 549

Roche Diagnostics
Operator’s Manual · Version 3.4 G-15
Cedex Bio analyzer Index
G
global action buttons, A–71
H
handling
– cuvettes, A–55
– lots, B–106
– orders, A–33
– reagents, A–26, A–56
– results, A–34
– samples, A–32
– software data, A–66
hardware
–overview, A–37
– specifications, A–65
heads, transfer, A–48
heating channel, cleaning, D–10
host
– configuration, B–177
– connectivity, A–33
– definitions, B–177
host codes, B–174
– screen, A–118
housing, cleaning, D–20
I
ignoring QC results, B–80
import, screen, A–122
importing
– applications, B–121, B–147
– certificates, B–125
– database, B–123
– extra wash cycles, B–125
– mixing information, B–125
– software, B–123
Initialize ISE reference sensor, maintenance action, F–51
Initialize ISE unit, maintenance action, F–57
installation, safety, A–7
installing
– applications, B–122, B–148
– ISE pump tubing, F–58
– ISE unit tubing, F–65
instrument
–See, analyzer.
intended use
–analyzer, 7
– of operator’s manual, 2
interface
–See, user interface
interfaces, specifications, A–66
internal waste tank, A–50
interpreting, QC History, B–81
Interval QC
– overview, B–74
– performing, B–77
intervals
– ISE maintenance actions, F–45
–maintenance actions, D–7
introduction
– See, overview.
inventory
– checking bottle sets, B–25, B–108
– deleting bottle sets, B–130
– screen, A–121
ISE
–calculation, C–31
– calculation Sol 1 factor, C–32
–calibration, F–12
– calibrator, priming, F–52
– checking status, F–23
– checks, C–31
– cleaning tower automatically, F–54
– cleaning tower manually, F–55
– cleaning tower off the analyzer, F–40
– conditioning tubing, F–50
– flags, F–75
– fluid containers, F–11
– installing pump tubing, F–58
– installing tubing, F–65
– list of flags, F–75
– main calibration, F–28
–maintenance, F–43
– measurement process, F–7
– measuring modes, F–6
– monitoring status, F–26
–operation, F–17
–overview, F–5
– preparing system, F–22
– priming calibrator, F–52
– principles of measurement, F–7
–pump tubing, F–58
– replacing pump tubing, F–58
– replacing tubing, F–61
–sensors, F–11
–solutions, F–8
–standby, F–12
– status, F–73
– test principle, C–32
– tower, F–40, F–54, F–55
–troubleshooting, F–71
– tubing, F–11, F–65
ISE calibration
– slope calculation, C–33
– slope out of range, C–33
– Sol 1 factor, C–34
ISE reference sensor, initializing, F–51