Rockwell Automation Publication IASIMP-QS005H-EN-P - April 2016 161
Chapter 6
Safety System Application Guide
Introduction
This chapter guides you through the pre-configured FactoryTalk® View ME Guard I/O™ Faceplate that interfaces with
the pre-configured GuardLogix® Guard I/O and Guard I/O Safety Add-On Instructions, SmartGuard™ 600 Add-On
Instructions, and Safety Device Routines. It also provides information about the Safety Instruction Faceplate. You will be
guided through the faceplate views, which provide the information you need to monitor your safety system and quickly
diagnose, take action, and restart your system.
Before You Begin
Complete both the Logix and FactoryTalk View ME software integration of your safety system, including download and
test.
What You Need
• Hardware installation and wiring complete with power applied
• Logic application file downloaded to your 1756 GuardLogix, 1768 Compact GuardLogix, or 5370 Compact
GuardLogix controllers, or your SmartGuard 600 controller
• Controllers are set to Run mode
• FactoryTalk View ME runtime application file downloaded to the PanelView™ Plus terminal with Run
Application activated on the terminal
To Next Page
Loading...